Changelog

Version 2026.0311.1445

  • Performer FX LED shows now an intermediate state (blinking) while transitioning and waiting for HIT in synced mode

  • New PERF ON/OFF system setting allows to either toggle FX (TRIG, old behavior, default) or set FX as a gate (GATE)

  • New LOCK MODEL system setting to prevent accidental model changes in a live set when using STUDIO mode. It is automatically turned off when powering up Bohm

  • New TAPS OUT system setting to select which envelope to output from Groove (GROOVE, old behavior, default), Inverted Bohm (I BOHM), Performer ducking (PERF) or (non-inverted) Bohm envelope (BOHM)

  • New IN VOL system setting to lower the volume of the external audio input

  • New PERF VOL system setting to select which signals are affected by the Performer volume slider/CV, either Bohm and Groove (B+G, old behavior, default) or only Bohm (BOHM)

  • New PERF MAX system setting to restrict the maximum volume when slider or CV is full on

  • New DUCK TIME model setting to change the release time of the ducking curve

  • New DUCK SMTH model setting to smooth the ducking curve

  • New DUCK BS model setting to set the maximum frequency below which the ducking is operating

  • New LAYER VOL setting in the XT-88 model, to set the volume of the layering sample

  • New POST EQ system settings as a sub-menu, with 1 low shelf, 1 peak filter (boost/cut) and 1 high shelf

  • OLP4 model now supports Groove

  • When using HIT in sustain mode (using a long gate), Bohm can now reach C1 and C2 for every position of CURVE

  • It is now possible to load a snapshop with pots positions, which allows to copy a snapshot or make tweaks when preparing a live performance

Version 2025.0827.1600

  • New engine version with system settings variations allows a system setting to now “talk” to the model

  • New GRV ENV system settings allows the Groove envelope to FALL after the 4th tap (new feature, now the default when at factory settings), or SUSTAIN (old behavior, drone)

  • Shop mode now also reset base system settings to their default on start, to ensure a consistent customer experience in shops’ showrooms

  • Fixed a flaw where 1 second was needed (for rate limiting) for a program clear or snapshot saving to be effectively written to internal memory. This is now immediate

  • New FACTORY RESET system menu, to put back Bohm at the same state as when it left the factory (ie. everything is reset apart from calibration)

  • New BACKUP and RESTORE menus to backup and restore the entire Bohm system (apart from calibration) to/from a file on the SD card

  • New end of chain soft clipper that prevents hard clipping when input signal is too strong. The soft clipper starts to slowly clip above 0dB (±5V in Eurorack), with the 4.6dB headroom the audio codec has

  • DJ FILTER (NEUTRAL/RAVE) has been changed to DJ RESO to control the filter resonance from 0% to 100%, in 10% increments. The RAVE lowest frequency in the LP portion used to be limited to 500Hz, this is no longer the case

  • New Stereo width variation for Groove and Bohm models, when the signal is not already mono

  • New PANNING system settings, allows each signals (Bohm, Groove, Audio Input) to be either stereo (default), hard-panned left or hard-panned right

Version 2025.0722.1625

  • Initial release